Wacom Tablet config on Thinclient

Ivan Pavan Lv1Posted 18 Jun 2019 22:58

Good morning,
I am testing the VDI system and cannot configure the Wacom Cintiq tablet on the VM.
The tablet is physically connected to the thinclient (STD-500) via USB 3.0 (on a front door) and via HDMI and the drivers are correctly loaded, but it is not configured by the VM.
Can someone help me? Thanks a lot!

edmund9706 has solved this question and earned 20 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Dear Ivan,

kindly refer to below link for your reference:

http://community.sangfor.com/plu ... atabase&tid=603
Is this answer helpful?
edmund9706 Lv1Posted 20 Jun 2019 18:08
  
Dear Ivan,

kindly refer to below link for your reference:

http://community.sangfor.com/plu ... atabase&tid=603
Apriyanto Lv4Posted 26 Jun 2019 10:59
  
hopefully the issue is solved
Wahid Lv2Posted 26 Jun 2019 11:38
  
you must read @edmund9706 share article
Ivan Pavan Lv1Posted 27 Jun 2019 00:23
  
Hi. I insert the VIDID code of the tablet in the "Mappings" folder of "USB device whitelist / blacklist", as suggested by the manual. The tablet is now recognized but the pointer does not follow the pen movement and does not work properly.
I opened a request for assistance, I hope to solve the problem soon.

I Can Help:

Change

Board Leaders