Aggregate Interface Load Balancing Mode

epsoft Lv1Posted 19 Jan 2020 14:15

Last edited by epsoft 19 Jan 2020 14:23.

To Setup LACP or TrunkAggregation on Interface,
which mode uses LACP or other Active/Active Trunk specification?

Active/standby (Mode:1) =
Based on MAC address (Mode:2) =
Based on MAC Address =
Round Robin among interfaces (Mode:0) =
Layer 4 load balancing (Mode:2) =

Is the Mode referring to Layer ISO/OSI stack?
If so, the Mode2 require to configure the corrisponding port on hw switch as LAG or LACP, but wich one corrispond to static LAG and to LACP?
(i'm wondering if the 'layer 4 load balancing (Mode:2)' can corrispond to LACP/802.3ad specs)

But also: What is the 'Based on MAC Address' (NOT Mode2) ?

Marco Barbieri has solved this question and earned 20 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

mode0 offer Active/Active Trunk based on cisco etherchannel specification (only round robin the connection)
mode2 offer Active/Active Trunk based on cisco etherchannel specification (source and destination MAC address HASH)
"Based on MAC Address ="  should be a wrong traslation, in previous version it was "Based on IP address (Mode:2) ="  offer Active/Active Trunk based on cisco etherchannel specification (source and destination IP address HASH)
those mode require stackable and manageble switches

bye
MArco
Is this answer helpful?
Marco Barbieri Lv1Posted 26 Mar 2020 06:03
  
mode0 offer Active/Active Trunk based on cisco etherchannel specification (only round robin the connection)
mode2 offer Active/Active Trunk based on cisco etherchannel specification (source and destination MAC address HASH)
"Based on MAC Address ="  should be a wrong traslation, in previous version it was "Based on IP address (Mode:2) ="  offer Active/Active Trunk based on cisco etherchannel specification (source and destination IP address HASH)
those mode require stackable and manageble switches

bye
MArco

I Can Help:

Change

Moderator on This Board

0
46
0

Started Topics

Followers

Follow

Board Leaders